Back: B.65 Rohde & Schwarz SMB100A Signal Generator Forward: B.67 Roper Scientific Spec-10 CCD Camera   FastBack: B. Device Reference Up: B. Device Reference FastForward: C. Reserved Words         Top: fsc2 Contents: Table of Contents Index: Index About: About This Document

B.66 Rohde & Schwarz SML01 Signal Generator

Module name: rs_sml01

Description: Rohde & Schwarz SML01 Signal Generator with support for output level normalization via frequency/amplitude table files.

Frequency range is 9 kHz to 1.1 GHz, attenuation range -140 dB to 13 dB in 0.1 dB steps.

Controlled via: GPIB bus (IEEE 488).
In the GPIB configuration file use "RS_SML01" as the device name, '\n' or 0xa as the EOS character, set set-reos and set-xeos to yes and set-bin to no.

Status: Tested

Supported functions:

`synthesizer_name()'
`synthesizer_state()'
`synthesizer_frequency()'
`synthesizer_step_frequency()'
`synthesizer_attenuation()'
`synthesizer_minimum_attenuation()'
`synthesizer_sweep_up()'
`synthesizer_sweep_down()'
`synthesizer_reset_frequency()'
`synthesizer_use_table()'
`synthesizer_attenuation()'
`synthesizer_automatic_level_control()'
`synthesizer_user_level_correction()'
`synthesizer_att_ref_freq()'
`synthesizer_modulation()'
`synthesizer_mod_ampl()'
`synthesizer_mod_type()'
`synthesizer_mod_source()'
`synthesizer_mod_freq()'
`synthesizer_pulse_state()'
`synthesizer_pulse_trigger_slope()'
`synthesizer_pulse_width()'
`synthesizer_pulse_delay()'
`synthesizer_double_pulse_mode()'
`synthesizer_double_pulse_delay()'

Back: B.65 Rohde & Schwarz SMB100A Signal Generator Forward: B.67 Roper Scientific Spec-10 CCD Camera   FastBack: B. Device Reference Up: B. Device Reference FastForward: C. Reserved Words

This document was generated by Jens Thoms Toerring on September 6, 2017 using texi2html 1.82.