Back: B.50 LeCroy Digitizing Oscilloscope 9424 Forward: B.52 LeCroy Digitizing Oscilloscope 9450   FastBack: B. Device Reference Up: B. Device Reference FastForward: C. Reserved Words         Top: fsc2 Contents: Table of Contents Index: Index About: About This Document

B.51 LeCroy Digitizing Oscilloscope 9424E

Module name: lecroy9424e

Description: LeCroy Digitizing Oscilloscope 9424E, 4 measurement channels, 2 function channels (needed for averaging), 2 memory channels, 350 MHz bandwidth. It is mostly identical to the LeCroy9424, but the fourth channel can't be used as a trigger input and the device has an external trigger input instead.

Controlled via: GPIB bus (IEEE 488).
In the GPIB configuration file use "LECROY9424E" as the device name, '\n' or 0xa as the EOS character, set set-reos and set-xeos to no and set-bin and set-eot to yes.

Status: Similar module for LeCroy 9450 works

Supported functions:

`digitizer_name()'
`digitizer_define_window()'
`digitizer_change_window()'
`digitizer_window_position()'
`digitizer_window_width()'
`digitizer_timebase()'
`digitizer_interleave_mode()'
`digitizer_time_per_point()'
`digitizer_sensitivity()'
`digitizer_offset()'
`digitizer_coupling()'
`digitizer_bandwidth_limiter()'
`digitizer_trigger_channel()'
`digitizer_trigger_level()'
`digitizer_trigger_slope()'
`digitizer_trigger_coupling()'
`digitizer_trigger_mode()'
`digitizer_trigger_delay()'
`digitizer_averaging()'
`digitizer_num_averages()'
`digitizer_record_length()'
`digitizer_trigger_position()'
`digitizer_meas_channel_ok()'
`digitizer_start_acquisition()'
`digitizer_get_curve()'
`digitizer_get_area()'
`digitizer_get_amplitude()'
`digitizer_run()'
`digitizer_copy_curve()'

Back: B.50 LeCroy Digitizing Oscilloscope 9424 Forward: B.52 LeCroy Digitizing Oscilloscope 9450   FastBack: B. Device Reference Up: B. Device Reference FastForward: C. Reserved Words

This document was generated by Jens Thoms Toerring on September 6, 2017 using texi2html 1.82.